Skip to Content

How To Turn Off The Oil Change Light in Jeep Renegade?

The oil change light is one of the more vexing lights to come on your Jeep Renegade dashboard. This light is typically used to alert the driver to the need for an oil change, although it may also glow in the event of low oil.

These lights are important in general since most drivers should be monitoring the miles on their vehicles but will overlook the 3 or 10 thousand mark, putting their engine’s internals at risk.

However, I’m here with this article to help those who don’t know what to do when the oil change light acts odd and how to turn off oil change light Jeep Renegade appropriately.

How To Turn Off The Oil Change Light in The Jeep Renegade?

If your dashboard’s change oil soon light is glowing, the simplest way to turn it off is to follow the light’s instructions and have your oil changed.

However, changing the oil may not always solve the problem, as a sensor can fail regularly or the problem is more serious than a simple oil change.

Taking the vehicle to a mechanic with the oil light on can allow the mechanic to assess whether there is an underlying problem that is being overlooked or if it is simply a sensor or fuse that needs to be replaced.

Depending on the model of vehicle you have, there are some methods you may perform at home to remove the oil light if it’s still on after you’ve changed the oil.

How to Reset Oil Light on Your Jeep Renegade?

It is noted that it is sometimes important to reset the oil light to turn off the oil change light.

Here are methods that will help you to reset the oil on your Jeep Renegade:

  • Without holding the brake pedal, turn the ignition switch to the ON position. Start the engine but don’t let it run.
  • Within ten seconds, slowly depress the gas pedal to the floor three times. (Various warning lights on the dashboard, including the oil warning light, will disappear with each press.)
  • Turn off the ignition and then turn it back on.

On the instrument panel, you should notice the words “Oil Change Reset.” This indicates that the oil light has been appropriately reset.

When the system senses that service is required, the indicator will glow again. Depending on your driving style, the distance traveled before the message shows can vary and vary.

If you can’t get the Jeep Renegade’s oil change notification light to reset the first time, try again. If you’re still having trouble, contact the shop for help resetting the Jeep Renegade’s oil life.

That’s all there is to it to turn off the oil reset light on your Jeep Renegade! The entire procedure takes less than thirty seconds, and the only thing you need to remember is to put the vehicle in park gear before pressing the gas pedal.

How to Change Oil for Your Jeep Renegade?

One important part has already been mentioned that changing the oil can often help you to turn off the oil change light on your Jeep Renegade.

Additionally, now that I’ve gone over how to reset the oil service light, let’s go over the oil change procedure. You should not reset the service light unless the car has been serviced since you risk seriously damaging the engine.

The Jeep Renegade’s engine utilizes synthetic oil, however, the specific type can be found in the owner’s manual or on the engine’s oil cap.

The full-synthetic 0W-20, 10W-30, and 5W-40 oils are the most often utilized.

Oil is considered toxic waste and must be collected and disposed of correctly; hence an oil drain pan is required.

A single nut on the oil sump holds back the oil. You’ll just need one wrench to remove the nut if you don’t plan on changing the oil filter.

However, I would recommend replacing the oil and air filters because both are about $20. An oil filter wrench is recommended since oil filters can be difficult to remove by hand.

Since the Jeep Renegade is a tall vehicle, you’ll probably be able to get beneath the engine bay without a car lift or a mechanic’s trench.

Wear clothes that you don’t mind getting soiled and rubber gloves to prevent oil from getting on your hands.

If Your Oil Light Is On, What Should You Do?

You may have orange check oil light or red check oil light depending on the car you are driving, and your vehicle may have both.

The orange check oil light on your Jeep Renegade is a general reminder for you to change the oil.

It’s also known as an oil change indicator light because it’s a simple reminder for you to replace the oil on your Jeep Renegade.

If your car’s oil light turns red, you’re in danger of damaging it and should pull over to the side of the road to analyze the problem.

Continuing to drive could cause damage to the engine owing to a shortage of oil or contamination of the oil that is already inside. If your oil light is flashing, you may have a sensor problem.

Having it looked at by a mechanic will help you evaluate the cost of repair as well as whether it is truly necessary.

  • The oil should be warm enough to flow more freely.
  • Put on your gloves and set a pan underneath the oil sump to catch any spills.
  • Unscrew the nut that holds the oil back with a wrench. If it falls into the drain pan, that’s fine, but be careful not to get oil on yourself.
  • After the oil has been removed, unscrew the oil filter with the oil filter wrench. When you remove the filter, be careful since there will be oil within.
  • Install the replacement filter and tighten the oil sump nut.
  • Remove the oil cap by opening the hood and unscrewing it. Close the cap after adding the recommended amount of oil.
  • Allow 30 seconds for the engine to run. Check the oil levels and, if necessary, add more.
  • Slowly remove the oil drain pan, then pour the oil back into the original containers using the handle as a funnel.
  • Taking the containers to a recycling center is a good idea.

Final Words

Since the sensor can fail frequently or the problem is more significant than a simple oil change, replacing the oil may not always address the problem when it is about to turn off the oil change light.

Taking the car to a repair with the oil light on can help the mechanic determine whether there is an underlying problem that is being neglected or if the problem is merely a blown sensor or fuse.

Hopefully, after reading this article, you now have the information to figure out how to solve such a problem with your Jeep Renegade.

Related Posts:

Share this article!

Leave a comment